Micro Sample Measurement

Micro Beam Lens Unit

This unit uses a lens and mask to mask the beam that passes through the integrating sphere opening. The minimum beam diameter is about 1 mm. It requires a sample base plate integrating sphere unit at the same time.

 

Note: For UV-2600, MPC-2600A and BIS-3100 sample base plate integrating sphere set is separately required.
For UV-3600Plus, MPC-603A and BIS-603 sample base plate integrating sphere set is separately required.
For SolidSpec-3700/3700DUV, BIS-3700/3700DUV is separately required.

Micro Sample Holder

This holds solid samples about 5 to 10 mm square or in diameter and about 1 to 5 mm thick. Samples are held by clamping from above and below.

For Research Use Only. Not for use in diagnostic procedures.

This page may contain references to products that are not available in your country. Please contact us to check the availability of these products in your country.

Top of This Page