User Benefits
Application
News
Fig. 2 Appearance of Samples
Fig. 1 IRSpirit™-X with QATR™-S Installed
Table 2 Analysis Conditions
Fig. 4 Spectrum from the Transparent Bead
Introduction
In recent years, there has been increasing interest in plastic
recycling internationally. The United States announced its
National Recycling Strategy
1)
on November 15, 2021, aiming to
increase the recycling rate to 50% by 2030. In Europe, an
amendment to Directive 94/62/EC on packaging and packaging
waste
2)
was announced on November 30, 2022, which proposes
packaging waste reduction targets by 2040, the introduction of
a common material labeling system, and a minimum recycled
plastic content in plastic packaging. In Japan, the Plastic
Resource Circulation Promotion Law came into effect on April 1,
2022.
Various sorting technologies, such as density separation,
electrostatic separation, near-infrared/infrared sorting, Raman
spectroscopy sorting, and X-ray transmission density sorting are
utilized in the process of plastic recycling. In particular, FTIR
spectrophotometer used for infrared sorting, allows for accurate
qualitative analysis of polymers and can identify polymers
regardless of their color or form (powder/solid), making it useful
for sorting a variety of plastics. Moreover, FTIR can be used not
only for qualitative analysis during collection but also for
confirming the ratios of different plastic types during the
acceptance of recycled plastics and for detecting contaminants
after molding.
FTIR spectrophotometers are useful for qualitative analysis of a wide variety of plastics.
With FTIR, it is possible to measure and analyze black or dark-colored plastics that cannot be measured by plastic automatic
sorting devices that utilize near-infrared light.
The Spectrum Advisor function ensures the acquisition of high-quality data.
FTIR Analysis of Recycled Plastics Using the
Spectrum Advisor Function
Xu Yan and Karen Maruyama
Fourier Transform Infrared Spectrophotometer IRSpirit™-X
Samples and Analysis Conditions
The transparent bead and black fragment used as plastic
samples for this measurement are shown in Fig. 2. The analysis
conditions are indicated in Table 1. The QATR-S was used as the
ATR attachment.
Transparent bead Black fragment
Instruments : IRSpirit-TX and QATR
™
-S (Diamond, Ge)
Resolution : 4 cm
-1
Accumulation : 45 times
Apodization Function : SqrTriangle
Detector : DLATGS
Qualitative Analysis of Transparent Bead
The transparent bead was placed on the prism (Fig. 3) and
spectra were obtained using the ATR method. The
measurement result is shown in Fig. 4. The peaks derived from
the bead were very weak, making qualitative analysis difficult.
Therefore, the Spectrum Advisor function was used to
investigate the cause.
Fig. 3 Transparent Bead Pressed against the ATR Prism
Spectrum Advisor
IRSpirit-X series Fourier transform infrared spectrophotometers
are compact and portable FTIR systems. Equipped with QATR™-
S, a built-in single reflection ATR measurement unit, IRSpirit-X
allows for easy measurement of variously shaped samples by
simply pressing them onto the prism. However, since plastics
brought for recycling come in various shapes, insufficient
sample pressing may result in poor spectra and make
qualitative analysis difficult. Additionally, spectra may also be
affected by the atmospheric environment in some cases. The
Spectrum Advisor function newly introduced in the IRSpirit-X
series compares the measured spectra with case models and
provides advice on parameters, accessories, and
troubleshooting related to data processing. As a result, high-
quality spectra can be acquired.
In addition to describing examples of plastic measurements,
this article also provides an overview of the Spectrum Advisor
function.