SolidSpec-3700/3700DUV

UV-VIS-NIR Spectrophotometer

SolidSpec-3700/3700DUV

High accuracy for transmittance and reflectance is required for the measurement of optical parts. The SolidSpec-3700/37000DUV have three detectors, which cover the range from ultraviolet to near-infrared. The sensitivity in the near-infrared region is extremely enhanced by using both InGaAs and cooled PbS detectors. Highly accurate and highly sensitive spectra are obtainable from ultraviolet to near-infrared.


solid0201

Conventional spectrophotometers have used a photomultiplier tube detector for the ultraviolet and visible region and a PbS detector for the near-infrared region. However, neither detector has much sensitivity near the detector switchover, which does not enable high sensitivity measurement in this range. The SolidSpec-3700/3700DUV enable high-sensitivity measurements in the switchover range by using an InGaAs detector.


High Sensitivity Measurement in NIR

solid0202

The transmittance spectra of a sharp cut filter measured on an InGaAs detector and a PbS detector (conventional spectrophotometer) are shown in the figure below. The SolidSpec-3700/3700DUV demonstrate lower noise between 850 and 1600nm. In the range from 1300 to 1600nm, comparing with the conventional spectrophotometer, noise is reduced to 1/4.
The SolidSpec-3700/3700DUV achieve less than 0.1% noise level under conditions of transmittance less than 1% in the range of 1300 to 1500nm.
High sensitivity in this wavelength range makes the SolidSpec-3700/3700DUV a powerful tool to measure low reflection samples, such as anti-reflective coatings or films used in optical communications.
Noise at 1500nm is at the world's lowest level: less than 0.00005Abs (slit width 8nm, RMS) with integrating sphere, and less than 0.00003Abs (slit width 2nm, RMS) with the Direct Detection Unit DDU/DDU-DUV.


solid0203

For Research Use Only. Not for use in diagnostic procedures.

This page may contain references to products that are not available in your country. Please contact us to check the availability of these products in your country.

Top of This Page